Characterization of the extracellular biodemulsifiers secreted by Bacillus cereus LH-6 and the enhancement of demulsifying efficiency by optimizing the cultivation conditions

A highly efficient demulsifying strain, LH-6, was isolated from petroleum-contaminated soil and identified as Bacillus cereus by 16S rDNA gene analysis. It achieved 95.61 and 95.40 % demulsifying ratios within 12 h for water-in-oil (W/O) and oil-in-water (O/W) model emulsions, respectively. Fourier transform infrared spectroscopy (FT-IR) and thin-layer chromatography (TLC) detections indicated that the LH-6’s extracellular biodemulsifiers were different types of lipopeptides for the W/O and O/W emulsions. Optimization of the culture medium composition was conducted to improve the biosynthesis and demulsifying efficiency of the biodemulsifier. The optimal carbon source was liquid paraffin, while waste frying oil could also be an alternative carbon source. The optimal nitrogen sources were ammonium sulfate and yeast extract. To further enhance the biodemulsifier efficiency, the optimal cultivation conditions were determined using response surface methodology (RSM) based on central composite rotation design (CCRD). Using the optimized cultivation conditions, the demulsifying ratios increased to 98.23 and 97.65 % for the W/O and O/W model emulsions, respectively.     

Fate and transformation of naphthylaminesulfonic azo dye Reactive Black 5 during wastewater treatment process

Certain aromatic amines generated by the decolorization of some azo dyes are not removed substantially by conventional anaerobic–aerobic biotreatment. These aromatic amines are potentially toxic and often released in the wastewater of industrial plants. In this study, the fate and transformation of the naphthylaminesulfonic azo dye Reactive Black 5 (RB5) during different phases of a sequencing batch reactor were investigated. The major products of RB5 decolorization during the anaerobic phase include 2-[(4-aminophenyl)sulfonyl]ethyl hydrogen sulfate (APSEHS) and 1-2-7-triamino-8-hydroxy-3-6-naphthalinedisulfate (TAHNDS). During the aerobic phase, APSEHS was hydrolyzed and produced 4-aminobenzenesulfonic acid, which was further degraded via dearomatization. TAHNDS was transformed rapidly via auto-oxidation into TAHNDS_DP-1 and TAHNDS_DP-2, which were not further removed by the activated sludge during the entire 30-day aerobic phase. In contrast, different behaviors of TAHNDS were observed during the anoxic phase. The transformation of TAHNDS was initiated either by deamination or desulfonation reaction. TAHNDS was then converted into 3,5-diamino-4-hydroxynaphthalene-2-sulfonic acid, which was subsequently removed via ring cleavage reaction under aerobic condition. In conclusion, complete degradation of TAHNDS by activated sludge occurs only during anoxic/aerobic processes instead of the conventional anaerobic/aerobic processes.     

好氧颗粒污泥自生动态膜生物反应器处理碱减量印染废水

自生动态膜生物反应器(SFDMBR)接种颗粒污泥启动,研究溶解氧浓度和水力停留时间对该反应器处理碱减量印染废水的影响。自生动态膜生物反应器形成稳定的动态膜后,出水浊度小于10 NTU,系统对浊度的去除率在90%以上,溶解氧和水力停留时间对反应器出水浊度基本无影响。系统对废水色度的去除率随着溶解氧浓度的提高和水力停留时间的延长而增加,但是系统对色度的去除效率一般不超过40%。溶解氧浓度由0.3 mg/L逐渐增大至2.4 mg/L,COD的去除率由40%提升至80%,而当溶解氧浓度大于1.0 mg/L后,UV254的去除率达到95%。水力停留时间在8~48 h时,COD去除效率由65%逐渐上升至85%左右;水力停留时间在8~32 h,UV254去除效率为68%~93%,超过32 h后水力停留时间对UV254去除效率的影响已不明显。     

电镀污泥的热处理特性以及对金属回收的影响

焙烧-酸浸法可有效回收电镀污泥中的有价金属,而污泥的热处理特性是决定能否采用焙烧预处理的重要因素。研究了氧化焙烧和还原焙烧对污泥成分和金属浸出性的影响,并对焙烧前后的污泥进行了金属形态分析和X射线衍射(XRD)分析。结果表明,焙烧预处理实现了污泥减量和金属富集;ES1经氧化焙烧后金属浸出率接近原泥,Cu的浸出率达99%;ES2的还原焙烧效果优于氧化焙烧,特别是Cu的浸出率超过97%,XRD分析发现,还原焙烧过程中金属Cu被还原为铁铜合金;2种焙烧均造成了ES3中目标金属Ni的浸出率的降低;金属浸出性的下降与残渣态的形成有关。     

广州白云国际机场飞机大气污染物排放分析

根据收集到的2008-2012年广州白云国际机场航班起降次数，参考《珠江三角洲非道路移动源排放清单开发》飞机污染物估算方法及排放因子，计算出此期间机场飞机大气污染物排放量，并与2010-2012年广州市机动车污染物排放情况对比。结果表明：飞机大气污染物排放量随客运量的增长呈逐年上升趋势，而与机动车排放相比，飞机大气污染物排放量较小，故现阶段仍应以机动车作为移动源污染控制的重点。     

中国典型河湖水体铅的水生生物安全基准与生态风险评价

采用物种敏感度排序法(SSR)对我国铅的淡水水生生物安全基准进行推导,并以太湖为例进行了流域水生生物安全基准推导。对于难以获得的本土生物毒性数据,开展了相应的毒性试验。获得了我国国家与太湖流域铅的水生生物安全基准值,基准最大浓度(CMC)分别为63.92、104.26μg·L-1,基准连续浓度(CCC)分别为1.21、4.06μg·L-1。同时,对我国主要河流以及太湖流域进行了铅的生态风险评价,联合概率曲线法显示影响5%水生生物种类的概率分别为66.22%和43.19%,熵值法则显示中国主要河流存在较大的铅暴露风险,因此,我国铅的潜在生态风险较大,主要河流与太湖流域存在铅污染问题。     

基于遥感反演长江中游地区悬浮泥沙研究

悬浮泥沙定量研究对于调查长江的水质、地貌、生态环境等起着至关重要的作用。以长江中游武汉地区2012~2013年14幅不同时相的Landsat ETM+遥感影像为主要数据源，结合野外采样悬浮泥沙浓度数据，分析了悬浮泥沙遥感定量反演方法，数据处理中针对ETM+SLC OFF影像缝隙问题，采用自适应局部回归匹配算法（ALR）进行影像自动恢复处理，在波段选择中对悬浮泥沙浓度和光谱反射率数据进行相关性分析，并运用传统关系建模方法和高斯模型方法对比，比较悬浮泥沙定量反演模型，利用实测验证数据对反演模型精度进行评估。研究结果表明：（1）ALR可以有效的获取悬浮泥沙敏感波段的遥感光谱反射率；（2）ETM+Band3悬浮泥沙浓度的高斯模型相关系数最高，通过对比得到模型反演的验证精度较高，研究证明遥感定量反演适合于长江流域武汉段泥沙含量大范围监测     

长三角经济能源约束下的大气污染问题及对区域协作的启示

长三角地区大气污染治理取得一定成效,然而空气质量改善逐渐进入瓶颈期和攻坚期,大气污染治理战略需要从宏观层面系统谋划。本文系统分析了近10年来长三角区域经济、能源、产业、交通的发展状况和趋势,结合区域大气污染物浓度水平的演变,分析了大气污染与经济社会发展的耦合关系。结合当前区域空气污染的空间分布差异以及经济能源交通结构的内在差别,识别了大气污染的区内差异特征及关键制约因素。在此基础上,从能源结构和产业结构调整、交通结构优化、分区施策、深化治理等角度,为深化区域大气污染联防联控,持续改善大气污染问题提出了政策建议。     

IC反应器处理MTO废水的中试研究

中试研究了内循环(IC)反应器处理甲醇制烯烃(MTO)废水的启动和运行过程,同时考察了颗粒污泥的性状及沼气产量的变化情况。试验过程运行稳定,系统抗冲击性强。以絮状污泥为接种污泥,经过131 d的启动和运行,IC反应器的COD去除负荷可达10 kg/(m~3·d)以上,COD去除率可达90%以上。IC反应器中的成熟颗粒污泥形状规则、密实、粒径大、沉降速率快。IC反应器的沼气产量符合理论预期。     

Fresh evidence on connectedness between prominent markets during COVID-19 pandemic

Environmental Science and Pollution Research - Various empirical studies have examined the nexus between financial markets, but this study focused on the comovement among prominent markets. Our...